7. Quit (No Save) — This command allows the user to exit the ESAM setup menu
and discard any changes made to the system's ESAM configuration settings during
the session. Its display is similar to
screen
Mini-Carrier Remote Fundamentals
Figure 50: SET ESAM: TRUNK PARAMETERS: BALANCE IMPEDANCE
screen
c. Termination Impedance — This variation of the SET ESAM
command allows the user to change the termination impedance of the
trunk from its default of 600 ohms. Its display is similar to
ESAM: TRUNK PARAMETERS: TERMINATION IMPEDANCE
screen:
on page 95.
Figure 51: SET ESAM: TRUNK PARAMETERS: TERMINATION IMPEDANCE
screen:
d. Dialing Speed — This variation of the SET ESAM command allows
the user to change the dialing speed of the trunk, from its default of
"DIGITONE." Its display is similar to
PARAMETERS:DIALING SPEED screen
Figure 52: SET ESAM: TRUNK PARAMETERS:DIALING SPEED screen
on page 96.
Figure 52: SET ESAM: TRUNK
on page 95.
Figure 53: SET ESAM: QUIT (NO SAVE)
Host MMI interface
Figure 51: SET
March 2013
95