Avaya Communication Server 1000M Single Group Manual page 59

Figure 11: Jumper settings on MCR circuit packs.
Installing the LMI
1. Set the DIP switches to specify the distance to the CSU, the MMI terminal baud,
2. Pull the LMI locking devices away from the faceplate. Holding the card by these
3. Slide the card into the module until it engages in the backplane connector.
4. Carefully push the locking device levers toward the faceplate to insert the card
5. The card LED should blink three times and then stay on until enabled by software.
Table 9: LMI SW2 at U23 functions
(SW2) at each position:
Table 9: LMI SW2 at U23 functions
Position
1-5
6
7
8
Mini-Carrier Remote Fundamentals
and the daisy-chain address. The DIP switch settings outlined in
at U23 functions on page 59 and
page 60 will depend on the physical system configuration.
locking devices, insert it into the card guides of the selected line card slots.
connector into the backplane connector and lock the card in place.
When enabled by software, the card LED turns off permanently, as long as the card
is operational.
Binary daisy chain address
OFF (not used)
OFF = MMI End, ON = Not MMI end
OFF = SDI End, ON = Not SDI end
Table 10: LMI SW3 at U51 functions
on page 59 shows the functions of LMI DIP switch 2
Usage
System installation
Table 9: LMI SW2
on
March 2013 59