Connecting The Intermediate Scsi Cable - Nortel CallPilot Installation And Configuration Manual

Installing the server, cables, and peripheral devices

Connecting the intermediate SCSI cable

Introduction
Before you can connect a CD-ROM or tape drive to the 200i server, you must
install the intermediate SCSI cable. Different cables are used for the Option 11
and Meridian 1. Therefore, part codes and installation procedures are different.
Part numbers
The following table gives the intermediate SCSI cable part codes for your
switch:
Switch type
Option 11
Meridian 1
To connect the cable for Option 11
On the Option 11, the intermediate SCSI cable bracket assembly is installed
below the card cage.
1 Remove the front panel of the Option 11.
2 Below the card cage, temporarily remove any cabling that might interfere
with the installation of the intermediate SCSI cable bracket assembly.
ATTENTION
50
Intermediate SCSI cable part code
NTRH1407 (with bracket assembly)
Two cables are required:


NTRH1408 (for connecting the 200i server to the
Meridian 1 I/O panel)


NTRH1409 (for connecting the Meridian 1 I/O panel
to an external SCSI device)
Services related to any telephony equipment associated
with the cabling should be taken out of service before the
cables are disconnected.
Standard 1.0
CallPilot