Initial System Installation-List Of Tasks In Subsections; Table 1 - Nortel Meridian 1 Manual

System installation procedures

Hide thumbs Also See for Meridian 1:

Table of Contents

Page 14 of 500

Initial Meridian 1 installation

553-3001-210 Standard 14.00 June 1999

15 Replace all covers and grills on the front and rear of the system.

Initial system installation—list of tasks in subsections

Prepare equipment for installation

Place the fourth module on a column

Position and level equipment

Install overhead cable tray kits

Install power supplies in all modules*

Install the disk drive unit(s)*

Install power equipment and ground wiring

Plan and designate the MDF

Install PFTUs

Configure the system monitor

Connect a system terminal (or modem)

Cable common equipment

Cable network loops

Cable lines and trunks

Power up the system and load system software

Perform acceptance tests

* See "System installation procedures" on page 12 and 2-3 for details on tasks that

are not described in subsections.

Chapters

Table of Contents