Nortel Meridian 1 Manual page 359

Procedure for installing Kit A
1 Insert the anchors into the holes. Use the manufacturer's setting tool to
install each anchor flush with the surface of the concrete. The setting tool
is required for the Hilti anchor.
2 Locate the two mounting plates for each column over the anchors. Place
an adapter bushing into each of the plate holes and insert a 3/4-inch
diameter bolt and flat washer as shown in Figure 116.
Figure 116
Mounting plate installation
Pedestal
Anchor holes
Adapter bushing
Installing earthquake bracing
System installation procedures
Page 321 of 500
Mounting plate
Anchor bolt
Shim
553-6071
553-6071