Installing Anchor Plates - Nortel Meridian 1 Manual

System installation procedures

Hide thumbs Also See for Meridian 1:

Table of Contents

Page 320 of 500

Installing anchor plates

553-3001-210 Standard 14.00 June 1999

Installing earthquake bracing

Using a carbide-tipped drill bit, hammer drill the holes to the size and

depth shown in Table 99.

Anchor hole sizes

Kit part number

Note: Special care should be taken in drilling the holes. The holes have

to be drilled straight and perpendicular to the floor surface in order for

the anchors to be installed correctly. The drill fixture kit can aid this

Should you hit reinforcing bar or the hole breaks through, abandon that

hole and use the secondary hole location indicated in the anchor hole

Remove any debris from the holes with a blowout bulb or compressed

air. Use a vacuum to dispose of the debris.

If the mounting plates are not to be installed immediately, cover the

anchor holes to prevent debris from falling into them.

The following tools are required to install the anchors and the anchor plates:

setting tool (Hilti HST 3/4", manufacturer part#329821)

1 1/8 inch open-end wrench

24 mm open-end wrench

Hole diameter

Table of Contents