Page 128 of 500
Figure 65
Modem to SDI port
RJ11
jack
Modem cable
(or NT8D46)
Public phone
network
RJ11
jack
Modem cable
(or NT8D46)
Note: The A0381391 modem can be used in this configuration.
553-3001-210 Standard 14.00 June 1999
Connecting a system terminal (or modem)
Smart mode
modem
RS-232
cable
Dumb mode
modem
Network module
— At the remote end, connect the cable from the modem to an RJ11
telephone jack. (If a cable is required, connect an NT8D46 cable to the
modem and to the RJ11 jack.)
— At the local end, configure the modem:
•
If you are using an A0381391 UDS FastTalk modem, follow the
instructions in this document. (See "Configuring an A0381391 UDS
FastTalk modem" on page 125.)
•
If you are using a different modem, follow the manufacturer's
instructions to set the modem for 9600 baud, autoanswer, dumb
mode, command recognition OFF, command echo OFF.
Remote end
SDI port on
I/O panel
NT8D95
cable
Terminal
553-5808
Rear View
553-5808