Nortel Meridian 1 Manual page 146

Page 108 of 500
553-3001-210 Standard 14.00 June 1999
Connecting a system terminal (or modem)
Installing a secondary system terminal (or modem)
1 Install and cable a system terminal or a modem:
• Unpack the terminal/modem and place it in its assigned location.
• Install the terminal/modem according to the manufacturer's
instructions.
• Connect an NT8D95AJ cable to a matching connector on the
terminal/modem.
Note: At a remote location, install and connect a compatible modem and
terminal. Connect the NT8D95AJ cable to the modem.
2 Install and cable the SDI card:
• Set the Enb/Dis switch to Dis (down).
• See Circuit card installation and testing (553-3001-211) to set the
option switches for each port.
See Figure 57 for switch locations on an NT8D41 SDI Paddle
Board. (The paddle board cannot be used in options 71, and 81.)
See Figure 58 for switch locations on an NTND02 MSPS Card. (The
MSPS card is used in option 21E only.)
• Insert the SDI card into its assigned slot.
• Cable the SDI card:
See Figure 59 to cable the NT8D41 SDI Paddle Board. (There is no
faceplate on the paddle board; Figure 59 identifies the ports.)
See Figure 60 to cable an NTND02 MSPS Card.
See Figure 61 to cable a QPC841 Four-Port SDI Card.
• Set the Enb/Dis switch to Enb (up).