APRILIA RSV4 RR Service Station Manual page 513

RSV4 RR/RF
•
Operate the brake lever and then open
the bleed valve on the calliper 1/4 of a
turn to let the air out.
•
Close the bleed again before reaching
the lever end of the stroke and repeat
the operation until there is no air.
•
Screw the bleeding valve and remove the pipe.
•
Top-up the reservoir until the correct brake fluid level is obtained.
•
Refit and lock the rear brake oil reservoir cap.
•
Refit the rubber protection cover.
Front brake pump
pos. Description
1 Screw fastening front brake fluid res-
ervoir to bracket
2 Screw fastening brake fluid reservoir
mounting bracket to handlebar
3 Front brake pump U bolt clamp
4 Front brake lever pin fixing screw
- Screw fastening brake pipe grommet
to the lower yoke
F
RONT BRAKE PUMP
Type Quantity
M6 1
M6 1
M6 2
M6 1
M5 1
Braking system
Torque Notes
7 Nm (5.16 lb ft)
7 Nm (5.16 lb ft)
10 Nm (7.38 lb ft)
10 Nm (7.38 lb ft)
8 Nm (5.90 lb ft)
BRAK SYS - 513
-
-
-
-
-