APRILIA RSV4 RR Service Station Manual page 333

RSV4 RR/RF
•
Install both chain sliders and fasten
them with the specific screws.
•
Rotate the crankshaft via the opening
on the clutch cover.
•
Position cylinder 1 piston (LH, rear pis-
ton) so that it is at the point where it
crosses TDC.
•
rotate the crankshaft 150° in the engine
rotation direction (direction of travel).
•
insert the respective pin, from the fly-
wheel side, into the groove on the
crankshaft.
NOTE
THE SPECIAL TOOL SHOWN HERE MUST ONLY BE USED
FOR IDENTIFYING THE CORRECT POSITION OF THE
CRANKSHAFT.
DO NOT USE IT FOR TIGHTENING COMPONENTS.
Specific tooling
020852Y Crankshaft timing pin
Engine
ENG - 333