APRILIA RSV4 RR Service Station Manual page 128

Electrical system
TABLE A1 - LICENSE PLATE HOLDER PRE-
FITTING
Bring all cables, including connectors in the hole
of the plate holder as in the picture and close all
paying attention not to pinch the cables
TABLE B - REAR ABS SPEED SENSOR PRE-
FITTING
1. ABS speed sensor
TABLE B1 - REAR ABS SPEED SENSOR PRE-
FITTING
1. ABS speed sensor wiring harness
2. Cable grommets
TABLE C - PROCEDURE FOR CORRECT ABS CONTROL UNIT CONNECTOR INSERTION
The initial position of the connector fastener lever must be as shown in the figure
ELE SYS - 128
RSV4 RR/RF