APRILIA RSV4 RR Service Station Manual page 465

Table of Contents

Advertisement

RSV4 RR/RF
The height of the swingarm pin relative to the
chassis is adjusted with special inserts installed in
the respective seats in the chassis. The hole is
offset by -5 mm (-0.197 in) relative to the centreline
of the insert, as a result the swingarm is in the low
position.
There are four inserts, subdivided as follows:
Inner/outer
Right/left
THE TWO LEFT SIDE SWINGARM PIN INSERTS ARE THE
SAME.
THE TWO RIGHT SIDE SWINGARM PIN INSERTS ARE DIF-
FERENT.
Refit the swingarm height adjustment inserts if removed, bearing in mind that the arrow must
face downward.
WARNING
PAY PARTICULAR ATTENTION TO THE DIRECTION OF THE INSERTS WHEN REFITTING. IN-
CORRECT ASSEMBLY MAY CAUSE SEVERE DAMAGE TO THE VEHICLE. THE ARROW MUST
FACE DOWNWARD.
Spread a thin layer of lubricating
grease all along the swingarm pin.
Fit the adjustment bushing (3) to its
seat and tighten it manually.
CAUTION
THE ADJUSTMENT BUSHING (3) MUST NOT PROTRUDE
BEYOND THE CHASSIS INTERNAL EDGE.
Place a wooden support under the
front of the swingarm to prevent it from
dropping and hold in position.
Support the swingarm from the front;
move it into position so that the holes
are aligned and simultaneously insert
the pin (2) fully.
Chassis
CHAS - 465

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rsv4 rf

Table of Contents