APRILIA RSV4 RR Service Station Manual page 295

RSV4 RR/RF
•
Remove the gearbox control rod spacer.
•
Remove the oil seal and the roller cage.
•
Install a new gearbox control rod roller cage on the spacer, using the specific tool without
an adaptor.
Specific tooling
020862Y Punch assembly cage with rollers gearbox control rod..............
•
Position a new oil seal on the spacer
with the writing on the edge of the oil
seal facing outward.
•
Install the oil seal on the spacer using
the specific tool without an adaptor.
Specific tooling
020862Y Punch assembly cage with rollers
gearbox control rod..............
Checking the gear selector
Check the stop lever for damage and wear and
make sure the ball rotates freely.
If necessary, replace the parts.
Check the gear selector spring for damage and
wear.
If necessary, replace the part.
Check the selector shaft and its teeth for damage
and wear.
If necessary, replace the part.
Check the lever spring for damage and wear.
If necessary, replace the part.
Reassembling the gear selector
•
To refit, lubricate and carry out the removal operations but in reverse order.
Engine
ENG - 295