APRILIA RSV4 RR Service Station Manual page 429

RSV4 RR/RF
•
Insert the pumping member pin unit.
•
Use the Öhlins tool to tighten the
pumping member pin fixing ring nut to
40 Nm (29.50 lbf ft).
•
Install the following components on the
wheel holder stanchion (1) in the order
given: dust gaiter (3), retainer ring (4)
and oil seal (5).
•
Fix the sleeve in a vice, taking care not
to damage the sleeve.
•
Insert the stanchion (1) into the sleeve
(2).
•
Fit the two half-shells of the special tool
on the wheel holder stanchion (1), be-
hind the oil seal (5).
•
Grip the special tool and push the oil
seal (5) into its seat on the sleeve (2).
•
Remove the tool.
Suspensions
SUSP - 429