APRILIA RSV4 RR Service Station Manual page 127

RSV4 RR/RF
TABLE N
Set the connectors for stand switch, Quick Shift
and gear sensor under the two corrugated pipes
TABLE N1
Check that the clamp holds all cables and espe-
cially the Quick Shift cable. The cable must be
locked so that it does not slide and comes into
contact with the exhaust.
1. Quick Shift wiring harness
2. Clamp
Back side
TABLE A - LICENSE PLATE FRAME PRE-FIT-
TING
The right arrow is identified with the RED taping
and must be inserted on the license plate holder
as indicated in the picture. The arrow with the red
tape must be connected with the wiring harness
branch that includes the grey tape
1. Left LED indicator
2. Right LED indicator
3. Grey tape
4. Red tape
Electrical system
ELE SYS - 127