APRILIA RSV4 RR Service Station Manual page 306

Engine
•
Remove the thrust bearing.
Checking the clutch plates
Characteristic
Maximum clutch plate deformation (in compar-
ison to a flat surface)
0.15 mm (0.0059 in)
Minimum wear limit of the clutch plate sliding
teeth
13.5 mm (0.53 in)
Minimum wear limit of the complete clutch
pack thickness (friction discs + steel discs)
47.6 mm (1.87 in)
Checking the clutch housing
Check the clutch bell for damage and wear that may result in clutch irregular operation. If necessary,
replace the bell.
Check the riveted joint between the clutch housing and the primary drive sprocket for correct sealing
and evenness.
ENG - 306
RSV4 RR/RF