Engine
•
Warm up the cover.
•
Using a generic extractor, it is then
possible to remove the bushing from
the cover.
INSTALLING THE CLUTCH CONTROL PIN
BUSHING
•
Before carrying out the installation of
the bushing, it is necessary to warm up
the cover.
•
Position the guide (1) to insert the
bushing (2) as indicated in the figure.
•
Insert the bushing so that the process-
ing notch (3) is aligned with the notch
on the guide (4).
Specific tooling
020926Y Tool for fitting clutch bushing
•
Then insert the tool to push the bushing
into the seat until it stops.
•
Position the starting transmission gear
on the crankcase.
•
Position the gasket and the two dowel
pins in the clutch cover.
•
Insert the clutch cover, making sure to
have correctly engaged the clutch con-
trol lever and the rack shaft.
ENG - 314
RSV4 RR/RF