Validation - Bosch Rexroth IndraControl S20 Manual

74/85 Bosch Rexroth AG
Checklists
14.5

Validation

IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
Checklist to commission and parameterize the module
Device type, equipment ID
Version: HW/FW
Editor
Notes
No. Request (mandatory)
1 Are all requirements listed as mandatory in the
"Planning" checklist met?
2 Are all requirements listed as mandatory in the
"Mounting and electric installation" checklist
met?
3 Are all requirements listed as mandatory in the
"Commissioning and parameterization" checklist
met?
4 Does the parameterization of the safe outputs
correspond to the design of the actual connec‐
tion of the receiving devices?
5 Was the assignment between the actuators and
the outputs and the variables of the safe appli‐
cation program checked (online status in the
Safety program)?
6 Was the function test to check all safety func‐
tions the module is involved in, performed?
7 Were actions taken to reach a certain category? □
8 Do all wires correspond to the specifications?
9 Does the power supply correspond to the speci‐
fication on the protective extra-low voltage acc.
to PELV?
10 Was the voltage supply from U
nected from a power supply unit in the
IndraControl S20 system?
11 Is the external protection of the module imple‐
mented (acc. to the specifications in the present
manual on the supply voltage U
12 Were actions taken against simple manipula‐
tion?
13 Are the requirements on the actuators and on
the cable routing met acc. to the SIL/SIL CL/
cat./PL to be reached?
14 Are the specifications on the parameterization
implemented in each channel?
15 Was the checksum (SCCRC) from the safe pa‐
rameterization applied to the safe configuration
of the project and loaded to the control?
DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
Date
Tester
Yes
□
□
□
□
□
□
□
□
and U con‐ □
O BK
□
)?
O
□
□
□
□
Notes