Bosch Rexroth IndraControl S20 Manual page 26

24/85 Bosch Rexroth AG
Mounting, demounting and electric installation
12-pin DIP switch: Address
Setting address
IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
S1 DIP switch to set the SDID and SNN
Fig. 5-1: DIP switch
Set the TUNID (SDID + SNN) for the CSos device.
The SDID addresses from 1 to 127 (1
The SNN addresses from 1 to 31 (1
The TUNID is shown as follows: TUNID =SDID*1000000000000
+ (600000000 + SNN)
hex
SNN
Address switch
4 3 2 1
MSB
SNN
1 to 1F
hex hex
MSB The MSB (most significant bit) has the highest significance.
LSB The LSB (least significant bit) has the lowest significance.
Tab. 5-1: Switch position at CSos
Example:
Calculating the TUNID using the DIP switch position
SDID: 23 = 17 ⇒ DIP switches 4, 2, 1 and 0 to "on"
hex
SNN: 1 = 1 ⇒ DIP switch 0 to "on"
hex
Resulting TUNID: 00000017000600000001
1. Remove the labeling field.
2. Set the address.
3. Attach the labeling field again to the module.
DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
TUNID
S 1
4 2 0
3 1
S NN
to 7F ) are permitted.
hex hex
to 1F ) are permitted.
hex hex
SDID
0 6 5 4
LSB MSB
SNN SDID
1 to 7F
hex hex
hex
off
on
5 3 1
6 4 2 0
S DID
hex
3 2 1 0
LSB
SDID