Checklists; General Information - Bosch Rexroth IndraControl S20 Manual

DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
14

Checklists

14.1

General information

The checklists listed in this chapter support the following actions at the mod‐
ule S20-SSDO-8/3: Planning, mounting, electric installation, commissioning,
parameterization as well as validation
These checklists can be used for planning and or as a proof of
performed working steps in the specified phases.
Archive the filled out checklists to use them as reference when performing re‐
curring checks.
This checklist does not replace validation, initial commissioning as well a reg‐
ular check by qualified staff.
The following excerpt shows a filled out list as example.
Checklist...
Device type, equipment ID
Version: HW/FW 00/1.01
Tester 1 John Doe
Notes System XXX was checked for hood manufacturing
No. Request (mandatory)
X ...
No. Request (optional)
Y ...
Equipment ID Enter device type and/or equipment ID for the ob‐
served module.
Version: HW/FW Enter hardware and firmware version of the module,
refer to
Date Enter the date when this list was started.
Tester 1/2 Enter the name of the tester.
Notes Enter the note if required.
Request (mandatory) These requirements are mandatory for a safety appli‐
cation to complete the corresponding phase with the
checklist.
Request (optional) These requirements are optional. Enter a note if any
points are open (cannot be fulfilled).
Bosch Rexroth AG
S20-SSDO-8/3 / S20-S3-BK+
Date
Tester 2
Yes
□
Yes No
□ □
chapter 3.2 "Module structure" on page
69/85
Checklists
17/01/2014
Jane Doe
Notes
Notes
11.