Bosch Rexroth IndraControl S20 Manual page 28

26/85 Bosch Rexroth AG
Mounting, demounting and electric installation
Attaching and removing plugs
IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
A
Fig. 5-4: Removing electronics module
Remove all connectors before removing the module.
Use a suitable tool (e.g. slotted screwdriver) and put it first into the upper and
then into the lower disengaging mechanism (base latch) of the module to dis‐
engage it (A).
Remove the module vertically to the mounting rail (B).
Fig. 5-5: Attaching plug
Set the plug vertically to its position. The plugs are color-coded, but not hard‐
ware-coded. Observe the colored markings of the plugs or slots. Assignment
from left to right: blue, red, white, green.
Press the plug down until it is fix. Ensure that the locking clip engages.
Fig. 5-6: Removing plug
Disengaging the locking clips (A).
Tilt the plug a bit up (B).
Remove the plug from the module (C).
DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
A
B
C
A
B
A