Guidelines And Standards; Intended Use; Documentation - Bosch Rexroth IndraControl S20 Manual

DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
Elaborate and implement a safety
concept!
Validating hardware and parame‐
terization
2.5

Guidelines and standards

2.6

Intended use

2.7

Documentation

Current documentation
The use of the module requires a safety concept for your machine or system.
These include the hazard and risk analysis and an inspection report (check‐
list) to validate the safety function, refer to
standards" on page 9
The target safety integrity (SIL acc. to IEC 61508, SILCL acc. to EN 62061 or
the performance level and category acc. to EN ISO 13849-1) results from the
risk analysis. The determined safety integrity depends on how the module is
to be wired and parameterized in the safety function.
Perform a safety validation in the complete system after each safety-relevant
change.
Ensure the following points are observed using your test report:
● The safe modules are connected to the correct sensors and actuators
● The parameterization of the safe input and output channels is correct
● The linking of the variables to the safe sensors and actuators (single-or
dual-channel) is correct.
The standards corresponding to the module are mentioned in the certificate
of the registration authority and in the EC declaration of conformity (refer to
www.boschrexroth.com/electrics).
The module S20-SSDO-8/3 is intended to be exclusively used in a CSos sys‐
tem. It can fulfill its tasks only if the specifications from this document are
used.
Use this module only according to the specified technical data and ambient
conditions, refer to
55.
This module is intended to connect single- or dual-channel actuators used
with safety engineering.
Example on module use:
● Single- or dual-channel E-STOP devices or protecting door devices
● Applications with enabling button
● Applications with two-hand circuits
● Applications with operation mode switches
● Downstream device for safety-related light barriers.
● Safety circuits acc. to EN 60204, part 1.
Ensure that the current documentation is consulted. For changes and supple‐
ments of the present documentation, go to the internet www.boschrex‐
roth.com ▶ Products ▶ Electric Drives and Controls ▶ CAD and documenta‐
tion ▶ Documentation
CSos When working with the Csos system and its components, these application
descriptions and the other documents on the product information have to be
available and observed. Observe the application descriptions of the following
products:
● The safe control used
and chapter 14 "Checklists" on page
chapter 11 "Technical data and ordering data" on page
Bosch Rexroth AG
For your safety
chapter 2.5 "Guidelines and
69.
9/85