Mounting, Demounting And Electric Installation; Mounting And Demounting; Unpacking The Module; Preparation And Mounting - Bosch Rexroth IndraControl S20 Manual

DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
5

Mounting, demounting and electric installation

5.1

Mounting and demounting

5.1.1

Unpacking the module

5.1.2

Preparation and mounting

5.1.3

Setting DIP switch

NOTICE
Comply with the required safety measures against electrostatic discharge
(ESD) acc. to EN 61340-5-1 and IEC 61340-5-2 when handling the module.
Read the package insert of the module and follow the instructions.
Only qualified staff is allowed to mount and demount the module.
WARNING
● Disconnect the complete IndraControl S20 station and secure the sys‐
tem against restart before mounting or demounting the module.
● Connect the voltage only after the system has been set up completely
and ensure that there is no hazard originating from the station or the
system. Observe the diagnostic displays and possible diagnostic mes‐
sages.
Install the module in a dust- and humidity-proof control cabinet or terminal
box (IP 54 or higher) on a 35 mm mounting rail.
Protect the control cabinet or the terminal box against opening by unauthor‐
ized parties.
To connect the cables, only use the IndraControl S20 plugs provided upon
delivery.
A DIP switch is located on the upper side of the module.
Bosch Rexroth AG
Mounting, demounting and electric installation
Module damage due to electrostatic dis‐
charge
Unintended machine startup due to installa‐
tion works without to ensure that there is no
voltage applied.
23/85