Planning - Bosch Rexroth IndraControl S20 Manual

70/85 Bosch Rexroth AG
Checklists
14.2

Planning

IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
Checklist to plan and use the module
Device type, equipment ID
Version: HW/FW
Editor
Notes
No. Request (mandatory)
1 Was the current user manual used for planning? □
2 Is it permitted to connect these actuators to the
module (according to the technical data and the
parameterization options)?
3 Was the power supply planned acc. to the spec‐
ifications on the protective extra-low voltage as
PELV?
4 Was the voltage supply from U
ned from a power supply unit?
5 Is the external protection of the module planned
(acc. to the specifications in the present manual
on the supply voltage U
6 Were actions planned against simple manipula‐
tion?
7 Were actions planned against interchanging the
plugs?
8 Are the requirements on the actuators and on
the cable routing observed acc. to the SIL/SIL
CL/cat./PL to be reached and is the implemen‐
tation planned?
9 Are the specifications on the parameterization
determined for each channel?
10 Are there any test intervals specified to test the
switch-off capability of the actuators if required
to meet an SIL/SIL CL/cat./PL?
11 Is it ensured that a purposeful start of hazard‐
ous motions is only possible when the danger
zone can be seen?
12 Does the planned use match the intended use?
13 Are the ambient conditions as well as the me‐
chanical load met as specified in the technical
data?
14 Are check intervals determined and was the
maximum service life considered?
15 Was the switch-off delay for stop category 1
considered when calculating the total response
time of the machine or system?
DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
Date
Tester
Yes
□
□
and U plan‐ □
O BK
□
)?
O
□
□
□
□
□
□
□
□
□
□
Notes
Revision: