Bosch Rexroth IndraControl S20 Manual page 19

DOK-CONTRL-S20*SSDO*8*-AP02-EN-P
IndraControl S20 Module With Safe Digital Outputs S20-SSDO-8/3
Name Color State
MS CSos module status
Off
Red/green flash‐
ing
GN
Green flashing
GN
Green on
GN GN
Flashing red
RD
Red on
RD RD
NE CSos safety network status
Off
Green flashing
GN
Green on
GN GN
Flashing red
RD
Red on
RD RD
Red/green flash‐
ing
GN
00-07 Status per output 0-7
Off
Green on
GN GN
Description
Self test or configuration is active or required.
RD
Module is in "Stop" state. The outputs are "0".
The outputs are valid.
Recoverable error. Recoverable errors are for example configuration errors of
the Csos firmware.
Unrecoverable error. It is possible that the module has to be replaced.
Module has no connection to the originator
The connection to the originator is established, but no I/O data is exchanged.
I/O data is exchanged with the originator.
I/O connection to originator failed.
An error was detected in the connection that does not allow further process‐
ing.
The module is ready to set a new TUNID via DIP switches. The new TUNID is
applied upon the next voltage startup.
RD
Output, logic "0".
Output, logic "1".
Bosch Rexroth AG 17/85
Product description