Wlan Tx-Power Auto Signal-Strength; Wlan Tx-Power Auto Signal-Loss - 3Com 3CRUS2475 Command Reference Manual

506 C 36: W
HAPTER
wlan tx-power auto
signal-strength
wlan tx-power auto
signal-loss
WLAN C
IRELESS OMMANDS
The wlan tx-power auto signal-strength Global Configuration mode
command configures the target signal strength heard at the
second-closest AP. To restore defaults, use the no form of this command.
Syntax
wlan tx-power auto signal-strength dbm
no wlan tx-power auto signal-strength
Parameters
dbm — Specifies the signal strength, in dBm. (Range: -40 dBm – -80
■
dBm)
Default Configuration
The default target signal strength is -68 dBm.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the target signal strength heard at the
second-closest AP to -50 dBm.
Console (config)# wlan tx-power auto signal-strength -50
The wlan tx-power auto signal-loss Global Configuration mode
command configures the minimum signal loss difference
(transmitted-received) below which two AP radios are considered too
close. To restore defaults, use the no form of this command.
Syntax
wlan tx-power auto signal-loss db
no wlan tx-power auto signal-loss