Snmp-Server Engineid Local - 3Com 3CRUS2475 Command Reference Manual

snmp-server
engineID local
The remote engineid designates the remote management station and
should be defined to enable the device to receive informs.
Example
The following example configures an SNMPv3 user John in a group called
user-group.
Console(config)# snmp-server user John user-group
The snmp-server engineID local Global Configuration mode command
specifies the Simple Network Management Protocol (SNMP) engineID on
the local device. To remove the configured engine ID, use the no form of
this command.
Syntax
snmp-server engineID local {engineid-string | default}
no snmp-server engineID local
Parameters
engineid-string—Specifies a character string that identifies the engine
■
ID. (Range: 5-32 characters)
default—The engine ID is created automatically based on the device
■
MAC address.
Default Configuration
The engine ID is not configured.
If SNMPv3 is enabled using this command, and the default is specified,
the default engine ID is defined per standard as:
First 4 octets — first bit = 1, the rest is IANA Enterprise number = 674.
■
Fifth octet — set to 3 to indicate the MAC address that follows.
■
Last 6 octets — MAC address of the device.
■
Command Mode
Global Configuration mode

snmp-server engineID local

289