Set - 3Com 3CRUS2475 Command Reference Manual

set

Example
The following example configures the trust state for a class called 'class1'
in a policy map called 'policy1'.
Console (config)# policy-map policy1
Console (config-pmap)# class class1
Console (config-pmap-c)# trust cos dscp
The set Policy-map Class Configuration mode command sets new values
in the IP packet.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos}
no set
Parameters
new-dscp — Specifies a new DSCP value for the classified traffic.
■
(Range: 0-63)
queue-id — Specifies an explicit queue ID for setting the egress
■
queue.
new-cos — Specifies a new user priority for marking the packet.
■
(Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
This command is mutually exclusive with the trust Policy-map Class
Configuration command within the same policy map.
Policy maps that contain set or trust Policy-map Class Configuration
commands or that have ACL classifications cannot be attached to an
egress interface by using the service-policy (Ethernet, Port-channel)
Interface Configuration mode command.
set 125