Deny (Ip) - 3Com 3CRUS2475 Command Reference Manual

deny (IP)

Example
The following example shows how to define a permit statement for an IP
ACL.
Console(config)# ip access-list ip-acl1
Console(config-ip-al)# permit rsvp 192.1.1.1 0.0.0.0 any dscp56
The deny IP-Access List Configuration mode command denies traffic if
the conditions defined in the deny statement match.
Syntax
deny [disable-port] {any | protocol} {any | {source source-wildcard}}
{any | {destination destination-wildcard}} [dscp dscp number |
ip-precedence ip-precedence]
deny-icmp
deny-igmp
deny-tcp
deny-udp
Parameters
disable-port — Specifies that the port is disabled.
■
source — Specifies the IP address or host name from which the packet
■
was sent. Specify any to indicate IP address 0.0.0.0 and mask
255.255.255.255.
source-wildcard — (Optional for the first type) Specifies wildcard bits
■
by placing 1s in bit positions to be ignored. Specify any to indicate IP
address 0.0.0.0 and mask 255.255.255.255.
destination — Specifies the IP address or host name to which the
■
packet is being sent. Specify any to indicate IP address 0.0.0.0 and
mask 255.255.255.255.
destination-wildcard — (Optional for the first type) Specifies wildcard
■
bits by placing 1s in bit positions to be ignored. Specify any to
indicate IP address 0.0.0.0 and mask 255.255.255.255.
protocol — Specifies the abbreviated name or number of an IP
■
protocol. The following table lists protocols that can be specified:
deny (IP) 45