Spanning-Tree Cost - 3Com 3CRUS2475 Command Reference Manual

214 C 15: S
HAPTER PANNING

spanning-tree cost

-T C
REE OMMANDS
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
Spanning tree is enabled on all ports.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example disables spanning-tree on Ethernet port g5.
Console(config)# interface ethernet g5
Console(config-if)# spanning-tree disable
The spanning-tree cost Interface Configuration mode command
configures the spanning tree path cost for a port. To restore the default
configuration, use the no form of this command.
Syntax
spanning-tree cost cost
no spanning-tree cost
Parameters
■
cost — Path cost of the port (Range: 1-200,000,000)
■
Default Configuration
Default path cost is determined by port speed and path cost method
(long or short) as shown below:
Interface
Port-channel
Long
20,000
Short
4