Dot1X Auth-Not-Req - 3Com 3CRUS2475 Command Reference Manual

dot1x auth-not-req

Field
EapolReqIdFramesTx
EapolReqFramesTx
InvalidEapolFramesRx
EapLengthErrorFramesRx
LastEapolFrameVersion
LastEapolFrameSource
The dot1x auth-not-req Interface Configuration (VLAN) mode
command enables unauthorized devices access to the VLAN. To disable
access to the VLAN, use the no form of this command.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Default Configuration
Access is enabled.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
An access port cannot be a member in an unauthenticated VLAN.
The native VLAN of a trunk port cannot be an unauthenticated VLAN.
For a general port, the PVID can be an unauthenticated VLAN (although
only tagged packets would be accepted in the unauthorized state.)
dot1x auth-not-req
Description
The number of EAP Req/Id frames that
have been transmitted by this
Authenticator.
The number of EAP Request frames
(other than Rq/Id frames) that have
been transmitted by this Authenticator.
The number of EAPOL frames that have
been received by this Authenticator in
which the frame type is not
recognized.
The number of EAPOL frames that have
been received by this Authenticator in
which the Packet Body Length field is
invalid.
The protocol version number carried in
the most recently received EAPOL
frame.
The source MAC address carried in the
most recently received EAPOL frame.
485