Show Ports Monitor - 3Com 3CRUS2475 Command Reference Manual

280 C 18: P
HAPTER ORT

show ports monitor

M C
ONITOR OMMANDS
GVRP is not enabled on the port.
The port is not a member of a VLAN, except for the default VLAN (will
automatically be removed from the default VLAN).
The following restrictions apply to ports configured to be source ports:
The port cannot be already configured as a destination port.
Maximum number of source ports can be up to eight.
Example
The following example copies traffic for both directions (Tx and Rx) on port
g8 (source port) to port 1 (destination port).
Console(config)# interface ethernet g1
Console(config-if)# port monitor g8
The show ports monitor Privileged EXEC mode command displays the
port monitoring status.
Syntax
show ports monitor
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how the port monitoring status is
displayed.
Console# show ports monitor
Source
Port
Destinatio Type
n Port
Status