BTI7800 Series Hardware Overview and Installation Guide
OPS Equipment
Table 80: Optical Protection Switch Kit - Dual Switch Card (BT7A39AS)
Component
OPS 1RU chassis
OPS 1+1 module pluggable
OPS system control card
OPS power card
OPS accessories kit (includes mounting brackets and DC power
cables)
Table 81: AC Power and Power Cables
Component
OPS AC power unit
212
Management of the OPS is performed using a Web GUI, reachable through the local
Ethernet ports on the OPS system control card. The OPS can also be discovered and
monitored by the proNX Service Manager.
The Optical Protection Switch is ordered as a kit, which includes the chassis, redundant
DC power, a control card, a switch card, and mounting brackets and cables
(Table 80 on page
212):
Equipment for AC operation is ordered separately
Component PEC
BT7A39AE
Quantity in Kit
Component PEC
1
BT7A39AA
1
BT7A39AB
1
BT7A39AC
2
BT7A39AP
1
BT7A39AD
(Table 81 on page
Notes
The OPS AC power unit takes AC input and provides
DC output to the OPS power card (BT7A39AP) over
a DC power cable (included). The AC power cable is
not included and must be ordered separately.
Two units are required per OPS (one unit for each
OPS power card (BT7A39AP)).
Copyright © 2019, Juniper Networks, Inc.
212):