Table 78: Rectifier Kits (continued)
Kit
Spare Rectifier
Table 79: Rectifier Shelf Rack Support
Issue
BTI7814 Rack size
Cabinet size
Shelf placement in rack
Installing the AC Rectifier
Copyright © 2019, Juniper Networks, Inc.
Component
2900 W Rectifier
Rack-Mounting Support
The following table describes the rack support for the shelf. For rack-mounting procedures
refer to
"Installing the AC Rectifier" on page
Safety and Electrical Requirements
NOTE:
NEBS Compliance Statement for GR-1089:
All centralized power sources not embedded into a BTI7800 chassis are
to be grounded to the Central Office (CO) electrical ground system (GND).
The return terminal of the power source is to be connected to the CO GND.
An external Surge Protection Device (SPD) is to be used at the AC power
service entrance.
Installing the rectifier involves the following procedures, which are described below:
Installing the cables to the DC feeds
1.
Mounting the rectifier shelf
2.
Ground the shelf
3.
Quantity
1
205.
Description
ANSI 19 in or ETSI 450 mm
ANSI 21 in or ETSI 500 mm
ANSI 23 in
19 in
ETSI 600 mm x 600 mm, 1.25"and 1.75" centers
Up to two at the top of the rack
One above the BTI7814
One below the BTI7814
Chapter 8: AC Rectifier (External)
Product Equipment
Code (PEC)
BT8A78ACM1
205