Powering the BTI7801 Chassis
Connecting the ESD Wrist Strap Cable
BTI7814 ESD Jack Locations
Copyright © 2019, Juniper Networks, Inc.
The AC PEM LEDs start to light up. The AC OK light turns solid green when the module
is ready.
Perform a voltage checklist. The voltage can be checked only at the breaker/fuse
8.
panel end where the AC power cable is terminated.
See
"BTI7802 AC PEM Specifications" on page 51
voltage values.
Repeat this procedure for the second AC PEM.
9.
You have successfully completed this procedure.
Installing and Cabling the BTI7801 DC PEM on page 105
Installing and Cabling the BTI7801 AC PEM on page 105
Installing and Cabling the BTI7801 DC PEM
The BTI7801 uses the same DC PEM as the BTI7802. See
BTI7802 DC PEM" on page 101
Installing and Cabling the BTI7801 AC PEM
The BTI7801 uses the same AC PEM as the BTI7802. See
BTI7802 AC PEM" on page 103
Plug in the supplied ESD wrist strap cable to the ESD jack on the chassis.
CAUTION:
Electrostatic Discharge (ESD) can damage module components,
causing complete or intermittent operational failures. ESD can occur when
a module is improperly handled. Use an ESD wrist strap whenever you open
the equipment, particularly when you are handling modules. To work properly,
the wrist strap must make good contact at both ends (that is, with your skin
at one end and with the chassis at the other).
BTI7814 ESD Jack Locations on page 105
BTI7802 ESD Jack Location on page 106
BTI7801 ESD Jack Location on page 106
There are two ESD jacks on the BTI7814 chassis:
At the front of the chassis, to the left of the air intake grill
At the rear of the chassis, below the Power Entry Modules
Chapter 4: Installing the BTI7800 Series Chassis
for the recommended AC PEM
for installation and cabling instructions.
for installation and cabling instructions.
"Installing and Cabling the
"Installing and Cabling the
105