Before You Begin; Installing Equipment - Juniper SSG 5 Serial Hardware Installation

SSG 5 Hardware Installation and Configuration Guide

Before You Begin

Installing Equipment

NOTE:
NOTE:
18

Before You Begin

The location of the chassis, the layout of the mounting equipment, and the security
of your wiring room are crucial for proper system operation.
WARNING: To prevent abuse and intrusion by unauthorized personnel, install the
SSG 5 device in a secure environment.
Observing the following precautions can prevent shutdowns, equipment failures,
and injuries:
Before installation, always check that the power supply is disconnected from
any power source.
Ensure that the room in which you operate the device has adequate air
circulation and that the room temperature does not exceed
Do not place the device in an equipment-rack frame that blocks an intake or
exhaust port. Ensure that enclosed racks have fans and louvered sides.
Correct these hazardous conditions before any installation: moist or wet floors,
leaks, ungrounded or frayed power cables, or missing safety grounds.
You can front-mount, wall-mount, or desk-mount an SSG 5 device. The mounting
kits may be purchased separately.
To mount an SSG 5 device, you need a number-2 phillips screwdriver (not provided)
and screws that are compatible with the equipment rack (included in the kit).
When mounting a device, make sure that it is within reach of the power outlet.
To rack-mount an SSG 5 device, perform the following steps:
1. Unscrew the mounting brackets on the tray with a phillips screwdriver.
SSG 5-WLAN users with the optional antennae need to remove the existing
antennae, then connect the new antenna through the side hole.
2. Align the bottom of the device with the base holes on the tray.
3. Pull the device forward to lock it in the base holes on the tray.
4. Using the screws, attach the mounting brackets to the device and the tray.
5. Place the power supply in the supply holder, then plug the power adapter into
the device.
.
104° F (40° C)