Table of Contents
Advertisement
BTI7800 Series Hardware Overview and Installation Guide
Table 38: BTI7800 Series Management and Traffic Modules (continued)
Module
96-Channel Amplifier (AMP1)
Wavelength Protection Switch (WPS4)
BIC modules
12x SFP+ BTI Interface Card (12x SFP+ BIC)
1x CFP BTI Interface Card (1x CFP BIC)
Passive modules
96-Channel Fixed Mux/Demux (FMD96)
1
Client ports 1 to 10 support QSFP+ transceivers and client ports 1, 2, 6, 7 support both QSFP+ and QSFP28 transceivers.
Module Installation and Removal Guidelines
108
Description
Provides DWDM composite signal
amplification in point-to-point
applications.
NOTE:
This module is not supported
on the BTI7801.
Provides revertive or non-revertive
wavelength protection switching.
For up to 12 SFP+ transceivers.
For 1 CFP transceiver.
Provides local fixed grid access to all
96 wavelengths in the DWDM 50-GHz
channel plan.
All management and traffic modules are hot-swappable. You can install or remove these
modules while the chassis is powered.
WARNING:
Use proper caution when working with the equipment. This chapter
might not cover every possible hazardous condition.
NOTE:
After installing a module or a BIC into a slot, you must wait a minimum
of 60 seconds before you can remove that module or BIC from the slot. This
allows time for the CMM to recognize that the module or BIC has been
inserted.
NOTE:
After removing a module or a BIC from a slot, you must wait a minimum
of 60 seconds before you can install another module or BIC (or that same
module or BIC) into the same slot. This allows time for the CMM to recognize
that the module or BIC has been removed.
PEC
Introduced
BT8A78AMP1
Release 1.1
BT8A78WPS4
Release 1.6
BT8A78SFP12G
Release 1.1
BT8A78CFP1G
Release 1.1
BT8A78MD03
Release 2.0
Copyright © 2019, Juniper Networks, Inc.
Advertisement
Table of Contents
