Table of Contents
Advertisement
UFM6 Installation Rules
Table 43: Installation Rules
Input voltage to AC PEM
100 VAC
110 VAC
180 VAC and above
Copyright © 2019, Juniper Networks, Inc.
NOTE:
Be familiar with the site, safety, and installation guidelines described
in
"Module Installation and Removal Guidelines" on page
Mark all fibers that you plan to disconnect from the UFM4 and reconnect to the UFM3.
1.
If the UFM being replaced contains a BIC in BIC slot 2, and if you want to reuse that
2.
BIC in the new UFM, follow the procedures in
the BIC from BIC slot 2.
Follow the procedures in
3.
to replace.
Wait a minimum of 60 seconds to allow time for the CMM to recognize that the UFM
4.
has been removed.
Follow the procedures in
5.
Follow the procedures in
6.
slot 1, and to reinstall the BIC that you removed in
Install a 100G Coherent CFP into the 1x CFP BIC.
7.
Reconnect all fibers.
8.
You have successfully completed this procedure.
Installation rules exist for the UFM6 when running on a BTI7814 powered with AC PEMs.
Maximum number of UFM6
modules
8
9
No restrictions are necessary.
The power available for other modules increases if you deploy fewer UFM6 modules
than the maximums specified in the scenarios above. This increase is equal to the power
saved for each UFM6 module allowed but not deployed. See
Power Consumption" on page 53
modules.
"Removing a BIC" on page 126
"Removing a UFM" on page 119
"Installing a UFM" on page 117
"Installing a BIC" on page 125
2
Power available for other modules
100 W
100 W
for the power consumption of the UFM6 and other
Chapter 5: BTI7800 Series Modules
108.
to remove
to remove the UFM4 you want
to install the UFM3.
to install a 1x CFP BIC into BIC
into BIC slot 2 of the UFM.
"BTI7800 Series Component
121
Advertisement
Table of Contents
