Table of Contents
Advertisement
How to change the copy features (continued)
Introduction
Procedure
218
Variable length default
Note: When the set variable length is longer than the original length,
the excess is output blank.
The variable length default feature sets up the default cut length for
each roll, for the variable length option, located on page 85.
Press [Custom Presets] to return to
Previous screen.
System features
Media Type and Width for Auto Mode
Stamp Location and Orientation
Date Stamp Format
Folder Setup
Auto/ Manual Mode
Media Cut Mode and Document
Orientation
Lead/Trail Edge Default Synchro
Variable length default
1. Enter custom presets. If needed, refer to page 174.
2. Select the copy features tab.
3. Use the arrow buttons to select the variable length default
feature.
4. Select open.
The variable length default screen is displayed.
Storage/Disk
Copy features
Manager
How to customize the MAX 200
Open
Advertisement
Table of Contents
