Table of Contents
Advertisement
How to change the system features (continued)
Introduction
Procedure
190
Loading stamp data
The loading stamp data feature allows you to load stamp data
automatically or manually from the floppy disk drive.
If the loading stamp feature is set to auto, the machine automatically
loads the stamp data at power-on. When set to manual, the machine
allows you to load the stamp data from the stamp pattern screen.
Press [Custom Presets] to return to
Previous screen.
System features
Time &Date
Auto Power Off
Auto Power save
Auto Clear/ Backlight Off
Attention Tone
Plotter Setup
Loading Stamp Data
1. Enter custom presets. If needed, refer to page 174.
2. Select the system features tab.
3. Use the arrow buttons to select the loading stamp data feature.
4. Select open.
The loading stamp data screen is displayed.
Storage/Disk
Copy features
Manager
How to customize the MAX 200
Open
Advertisement
Table of Contents
