Table of Contents
Advertisement
Identifying the system features (continued)
Feature
Plotter setup, page 183.
Set default time
to plot, page 183.
Set delay time to
copy, page 185.
Folder, page 187.
Loading stamp data,
page 190.
Additional setting, page
192.
Automatic switching
from roll to tray (copy
mode)
Automatic switching
from roll to tray (plot
mode)
The starting point of
stamp location
Synchronized cutting
with auto mode
Default cut mode for
auto mode when
default for manual
mode is set to long
copy.
How to customize the MAX 200
Feature description and options
Allows access to setup the plotter interface defaults.
Sets up the delay time for switching to copy mode from plot mode.
Options:
10 sec., 1 minute, 3 minutes, 5 minutes, 10 minutes,
20 minutes.
Sets up the delay time from copy mode to plot mode.
Options:
no delay, 30 sec., 1 minute, 3 minutes, 5 minutes,
7 minutes, 10 minutes.
Sets up the default fold for plot mode (this feature is not used with
some plotter software).
Options:
P1, no fold, P2, P3.
Sets the default for stamp data to be loaded manually or automatic.
Options:
auto load, manual load.
Provides additional system settings for future needs.
Code: 10
Options:
Code: 11
Options:
Code: 110
Options:
Code: 200
Options:
Code: 210
Options:
on (0), off (1).
on (0), off (1).
lead edge (0), tail edge (1)
off (0), on (1)
standard (0), synchronized (1)
169
Advertisement
Table of Contents
