Table of Contents
Advertisement
Scanner control panel (continued)
Introduction
Procedure
Scanner document feed panel
28
Power save button
Note: For detailed information on how to setup power save, in
custom presets, refer to page 178.
The power save function reduces machine power consumption when
the machine is not used for a selected period of time.
When the machine enters the power save mode, current to the fuser
is reduced, and the electrical control signals (except auto mode
panel and scanner control panel) are switched off.
The power save feature in custom presets, can be set from 1 to 30
minutes, or the feature can be disabled entirely by entering No
minutes. The factory default is set to No minutes.
The interval timer clock is reset whenever the power save button is
pressed and the machine is currently in the power save mode.
If the machine is in power save mode and you would like to begin
making copies, press the power save button. Once the machine
completes the warm-up cycle and the ready to copy message is
displayed, you may begin coping again.
1. Press the power save button.
The power save indicator lamp is lit.
The machine enters the power save mode.
2. To exit the power save mode, press the power save button.
The scanner document feed panel, located below the scanner
control panel, displays the document feed direction.
When the ready message is displayed, you can begin scanning your
documents.
Getting to know the MAX 200
Advertisement
Table of Contents
