NEC SL2100 Features And Specifications Manual page 97

ISSUE 1.0
Required Component(s)
None
Related Features
Abbreviated Dialing/Speed Dial
Central Office Calls, Placing
Code Restriction/Toll Restriction
Dial Tone Detection
Trunk Group Routing
Trunk Queuing/Camp On
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
ARS with trunk group routing
Program Program Name
No.
11-09-01 Trunk Access Code - Trunk Access Code
14-05-01 * Trunk Group - Trunk Group Setup
26-01-01 * Automatic Route Selection (ARS/F-Route) Serv-
ice - ARS Service
26-02-01 * Dial Analysis Table for ARS/LCR -
Dial
26-02-02 * Dial Analysis Table for ARS/LCR -
ARS Service Type
Features and Specifications Manual
Input Data
Dial (Up to four digits)
Trunk Port 1 ~ 128 = Priority 1 ~
128
Trunk Group : 0 ~ 50
0 = Disabled (ARS service is
OFF.)
1 = Enabled (ARS service is
ON.)
Maximum of 16 digits (0 ~ 9, ,
*
#, @)
0 = No Service (Call Restricted)
1 = Route to Trunk Group
2 = Select F-Route Access
SL2100
A
Default
0
Refer to the Program-
ming Manual for the
default values.
0
No Setting
0
1-83