Table 1-50 Caller Id Sent To Mobile Telephone - NEC SL2100 Features And Specifications Manual

SL2100
• Transferred Trunk Call without CID -
- Transferred before inter-digit timeout - CPN of Mobile Extension is presented to the Mobile
Extension.
- Transferred after inter-digit timeout - CPN of the Transferring Phone's CPN is presented to the
Mobile Extension.
Only when the outbound trunks are ISDN or SIP trunks.
*
** ISDN will need to accept the inbound Caller ID as the Calling Party Number (CPN) presentation for
the outbound call.
Inbound Trunk
M
Analog CID
Analog CID
ISDN PRI
ISDN PRI
Analog CID
Analog CID
ISDN PRI
ISDN PRI
Conditions
• If the extension has Call Forward-Both Ring set to another extension, it will only continue to forward
if the Both ring location is forwarded (B/NA or NA) to VM and no where else.
• Analog, ISDN and SIP trunks are supported for the outbound call to the Mobile Extension.
• It is recommended that this feature uses ISDN platform (as these trunks provide answer
supervision).
• The analog line must provide CLI information to allow the Mobile Extension to dial into the system to
access features.
• For the extension DTMF, the minimum Detect Level for the DTMF Tone (PRG 80-03-03) must be
set to allow a minimum detection level of -25dBm. This entry is dependent on the Detect Level
selected in PRG 80-03-01.
• The Mobile Extension uses the
be changed (PRG 11-10, PRG 11-11, PRG 11-12, PRG 11-13).
• To provide a proper disconnect, Disconnect Supervision is required for the trunks used for this
feature.
• When an entry is made in PRG 15-22-01 for a Mobile Extension, ports are reserved for Mobile
Extension usage in groups of 4.
• To keep consecutive port numbering for units, you may wish to consider starting Mobile Extensions
at the upper extension port range.
• Calls on Mobile Extension can be easily picked up from a telephone in the system. This is done via
a Barge-In key (34+Mobile Ext # or 34+
Ring is set to. If no Forward Both Ring is set, the key will act as a basic Barge-In key.
• If the main terminal has call forward both ring set to the Mobile Extension and the Ecology-Power
Cutting feature removes power to the terminal any calls sent to the terminal will not go to the Mobile
Extension.
Default Settings
No Mobile Extensions are configured.
1-620

Table 1-50 Caller ID Sent to Mobile Telephone

Outbound Trunk
CFA Analog
CFA ISDN PRI/SIP
CFA ISDN PRI/SIP
CFA Analog
CFNA Analog
CFNA ISDN PRI/SIP
CFNA ISDN PRI/SIP
CFNA Analog
to perform a flash, so any service codes which begin with
*
) will Barge-In to the Extension that Call Forward Both
* *
ISSUE 1.0
Y/N
N
Y
Y
N
N
Y
Y
N
must
*
Mobile Extension