NEC SL2100 Features And Specifications Manual page 836

SL2100
Trunk Disconnect Continue/Disconnect Codes
Program
No.
14-01-25 Basic Trunk Data Setup - Continued/Discontin-
ued Trunk-to-Trunk Conversation
20-28-01 Trunk to Trunk Conversation - Conversation
Continue Code
20-28-02 Trunk to Trunk Conversation - Conversation Dis-
connect Code
20-28-03 Trunk to Trunk Conversation - Conversation
Continue Time
24-02-07 System Options for Transfer - Trunk-to-Trunk
T
Transfer Release Warning Tone
24-02-10 System Options for Transfer - Disconnect Trunk-
to-Trunk
25-07-07 System Timers for VRS/DISA - Long Conversa-
tion Warning Tone Time
25-07-08 System Timers for VRS/DISA - Long Conversa-
tion Disconnect Time
80-01-02 Service Tone Setup - Basic Tone Number
(35)
Operation
Method A - Tandem Trunking from Conference
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press the Conf softkey.
3. Place or answer second trunk call.
4. To set up the tandem call, press the Conf softkey.
This sets up a Conference between you and both outside parties.
5. Press Transfer key.
- OR -
Press Hold key and dial #8 or the service code set for Unsupervised Conference/Tandem
Trunking in PRG 11-12-57.
The line keys for the trunks blink green as long as the Unsupervised Conference continues.
To end the Tandem Call:
1. Press either flashing line key.
The line keys light steadily (green). You can listen (i.e., monitor) to the call or rejoin the conversation,
based on the setting in PRG 20-13-10.
1-822
Program Name Input Data
0 = Disable (No)
1 = Enable (Yes)
0 ~ 9, , #
*
(Set for one digit only)
0 ~ 9, * , #
(Set for one digit only)
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0~33
0 = No Tone
33 = Default Time Slot
Tandem Trunking (Unsupervised Conference)
ISSUE 1.0
Default
0
No Setting
No Setting
0
1800
0
1800
30
Refer to Programming
Manual.