NEC SL2100 Features And Specifications Manual page 555

ISSUE 1.0
Program Program Name
No.
26-12-01 Network Specific Parameter Table for ARS -
Called Party Number - Type of Number Selection
26-12-02 Network Specific Parameter Table for ARS -
Called Party number - Numbering Plan Identifica-
tion Selection
44-05-11 ARS/F-Route Table - Network Specified Parame-
ter Table
SMDR Dialed Digits for either ISDN - BRI or PRI:
Program Program Name
No.
35-02-15 SMDR Output Options - CLI/DID Number Switch-
ing
35-02-16 SMDR Output Options - Trunk Name or Received
Dialed Number
General ISDN Programs:
Program Program Name
No.
14-01-13 Basic Trunk Data Setup - Trunk-to-Trunk Trans-
fer
15-02-29 Multiline Telephone Basic Data Setup - PB Back
Tone Level
15-07-01 Programmable Function Keys
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
20-09-02 Class of Service Options (Incoming Call Service)
- Caller ID Display
20-09-03 Class of Service Options (Incoming Call Service)
- Sub Address Identification
20-11-11 Class of Service Options (Hold/Transfer Service)
- Automatic On-Hook Transfer
20-11-14 Class of Service Options (Hold/Transfer Service)
- Trunk-to-Trunk Transfer Restriction
20-11-21 Class of Service Options (Hold/Transfer Service)
- Restriction for Tandem Trunking on Hang Up
Features and Specifications Manual
Input Data
0 = System Default
1 = Unknown
2 = International No.
3 = National No.
4 = Network Specific No.
5 = Subscriber No.
6 = Abbreviated No.
0 = System Default
1 = Unknown
2 = ISDN Plan
3 = Data Plan
4 = Telex Plan
5 = National Standard Plan
6 = Private Plan
0 ~ 16
Input Data
0 = CLI (CLIP)
1 = DID Calling Number
2 = Calling Party Name
0 = Trunk Port Name
1 = Received Dialed Number
2 = Both
Input Data
0 = Disable (No)
1 = Enable (Yes)
1 ~ 63 (- 15.5 dB ~ + 15.5 dB)
-
1 ~ 15
0 = Off
1 = On
0 = Off
1 = On
0 = Off
1 = On
0 = Off
1 = On
0 = Allow
1 = Deny
SL2100
Default
0
0
0
Default
0
0
Default
1
32 (0 dB)
Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
Extension 101 is Class
15 and other Extension
are Class 1
COS 01 ~ 15 = 1
COS 01 ~ 15 = 0
COS 01 ~ 15 = 0
COS 01 ~ 15 = 0
COS 01 ~ 15 = 0
1-541
I