Table 1-52 Keys For Entering Names - NEC SL2100 Features And Specifications Manual

SL2100
Guide to Feature Programming
Program
No.
11-11-22 Service Code Setup (for Setup/Entry Operation) -
Extension Name Programming
14-01-01 Basic Trunk Data Setup - Trunk Name
N 15-01-01 Basic Extension Data Setup - Extension Name
20-09-02 Class of Service Options (Incoming Call Service)
- Caller ID Display
20-13-21 Class of Service Options (Supplementary Serv-
ice) - Extension Name
20-13-47 Class of Service Options (Supplementary Serv-
ice) - Station Number Display
20-13-48 Class of Service Options (Supplementary Serv-
ice) - Station Name Display
20-13-51 Class of Service Options (Supplementary Serv-
ice) - Number and Name appear in the Directory
Operation
Refer to Table 1-52 Keys for Entering Names on page 1-646
to enter names.
Use this keypad digit . . .
Clear/Back or DND (2W Digital/IP Multi-
line Terminal)
1-646
Program Name

Table 1-52 Keys for Entering Names

When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters:
*
# # = Accepts an entry (only required if two letters on the same key are needed - ex:
TOM). Pressing # again = Space. (In system programming mode, use the right ar-
row Softkey instead to accept and/or add a space.)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Input Data
0~9, , # Maximum of 8 digit
*
Up to 12 characters
Up to 12 Characters
0 = Off
1 = On
0 = Off
1 = On
0 = Off
1 = On
0 = Off
1 = On
0 = Off
1 = On
for and explanation for using the keypad
Á À Â Ã Å Æ Ç É Ê ì ó 0
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
ISSUE 1.0
Default
700
Trunk Port Number 1 =
Name Line 001
Trunk Port Number 2 =
Name Line 002
:
Trunk Port Number 128
= Name Line 128
No Setting
COS 01 ~ 15 = 1
COS 01 ~ 15 = 1
COS 01 ~ 15 = 1
COS 01 ~ 15 = 1
COS 01 ~ 15 = 1
Name Storing