Setting The Print Heater Temperature - Roland TrueVIS VF2-640 User Manual

Adjusting the Ink-drying Method

Setting the Print Heater Temperature

Setting the temperature of the print heater appropriately improves ink adhesion and inhibits smudging.
• With the default settings, simply switching on the power does not make the dryer warm up to the set temper-
ature. The temperature rises to the set temperature when the media is loaded correctly and [SETUP] lights.
• Depending on the usage environment, the temperature of the print heater may become higher than the set
temperature, but this does not represent a problem.
• Temperature settings are not possible when heater settings "POWER" is "OFF".
Procedure
1.
Press [FUNCTION].
2.
Press [▼] several times to display the screen shown below.
FUNCTION
HEATER CONFIG
3.
Press [▶] or [▼] to display the screen shown below.
HEATER CONFIG
PRINT
4.
Press [▶] to display the screen shown below.
PRINT
40゜C
5.
Press [▲] or [▼] to select the temperature.
If the ink forms lumps or smudges, raise the temperature. Note, however, that a temperature that is too
high may degrade the media or cause it to wrinkle.
You can also set the temperature to "OFF". When set to "OFF", the print heater does not operate at all.
6.
Press [ENTER] to confirm your entry.
7.
Press [FUNCTION] to go back to the original screen.
MEMO
• Default setting: 40°C (104°F)
• You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software
RIP's setting is used.
RELATED LINKS
・ P. 90 "Switching Off the Print Heater and Dryer Together"
84
1. Optimizing the Output Quality
40゜C
40゜C