Roland TrueVIS VF2-640 User Manual page 74

10.
Press [◀] or [▼] to display the screen shown below.
CALIBRATION
TEST PRINT
11.
Press [ENTER].
Printing of the test pattern starts.
12.
Check the test pattern to see whether the correction was successful.
Check that the gap and overlap are the smallest for the figure indicated by "
rection value). If the gap and overlap are smaller for another figure, set the correction value again.
13.
When you have successfully performed the correction, press [MENU] to go back to the original screen.
MEMO
Depending on the software RIP you are using, you can also configure this setting in the software RIP (by, for example,
choosing the media type). When you have made the setting in the software RIP, the software RIP's setting is used and the
printer's setting is ignored.
Using the Correction Functions
" (that is, the current cor-
1. Optimizing the Output Quality
73