Error Messages; Option Dryer Is Not Connected; Temperature Is Too Low **ﾟC; Temperature Is Too High **ﾟC - Roland TrueVIS VF2-640 User Manual

Error Messages

This section describes the error messages that may appear on the machine's display, and how to take action to
remedy the problem. If the action described here does not correct the problem or if an error message not descri-
bed here appears, contact your authorized Roland DG Corporation dealer.

"OPTION DRYER IS NOT CONNECTED"

When [OPTION DRYER] is set to "ENABLE" with no auxiliary drying unit connected to the printer.
Switch the sub power and main power off, and then connect the auxiliary drying unit to the printer.
"TEMPERATURE IS TOO LOW **ﾟC"
The temperature of the location where the machine is installed has fallen below the ambient temperature at
which the machine can operate.
Operation cannot be continued. Turn off the sub power. The displayed temperature is the current ambient temper-
ature of the installation location. Bring the installed location to a temperature at which operation is possible (20 to
32°C [68 to 90°F]), allow the machine to come to room temperature, and then turn on the power.
"TEMPERATURE IS TOO HIGH **ﾟC"
The temperature of the location where the machine is installed has risen above the ambient temperature at
which the machine can operate.
Operation cannot be continued. Turn off the sub power. The displayed temperature is the current ambient temper-
ature of the installation location. Bring the installed location to a temperature at which operation is possible (20 to
32°C [68 to 90°F]), allow the machine to come to room temperature, and then turn on the power.

"CAN'T PRINT CROP CONTINUE?"

The size of the data including the crop marks is larger than the printing area of the loaded media.
To continue performing output without correcting this, press [ENTER]. At this time, the crop marks and the portion
extending beyond the printing area are not output. To stop output, stop sending data from the computer, and then
raise the loading lever. Make the printing area wider, for example, by replacing the media with a larger piece of
media, and then send the data again.
The size of the data being output is too small.
Make the horizontal‐direction (scan‐direction) size of the data at least 65 mm (2.6 in.). To continue performing
output without correcting this, press [ENTER]. At this time, the data is output without printing the crop marks. To
stop output, stop sending data from the computer, and then raise the loading lever. Change the size of the data,
and then send the data again. There is no limitation on the size of the data in the media-feed direction.

"SHEET TOO SMALL CONTINUE?"

The size of the data is larger than the printing area of the loaded media
To continue performing output without correcting this, press [ENTER]. At this time, the portion extending beyond
the printing area is not output. To stop output, stop sending data from the computer, and then raise the loading
lever. Make the printing area wider, for example, by replacing the media with a larger piece of media, and then
send the data again.

"DATA ERROR CANCELING..."

Output was stopped because a problem was found in the received data.
Operation cannot be continued. Completing the data cancellation will clear the message. Check for a problem with
the connector cable or the computer, or if the printer data has any defects (a color is designated that cannot be
output, etc.). Once the problem or defect has been corrected, send the data again.

"SHEET SET ERROR SET AGAIN"

"SHEET TYPE" is set to "OPAQUE", but transparent media was loaded.
192
4. Messages on the Operation Panel